Illinois Air Brakes CDL Practice Test

25 realistic Air Brakes practice questions for Illinois CDL applicants. Required for: Vehicles equipped with air brake systems. Official test: 25 questions, 20 correct to pass.

25Practice questions
25Questions on the official test
20 of 25Required to pass
Illinois Secretary of State — Driver ServicesTest administrator
Question 1 of 25 · Inspection

How much air pressure (psi) loss is allowed per minute for single vehicles with the engine off and brakes released?

  • A. Up to 1 psi
  • B. Up to 2 psi
  • C. Up to 3 psi
  • D. Up to 4 psi
Question 2 of 25 · Compressor

What is the purpose of an alcohol evaporator?

  • A. Reduce alcohol in the driver's system
  • B. Reduce risk of frozen brake valves and lines in cold weather
  • C. Improve fuel economy
  • D. Lubricate the air compressor
Question 3 of 25 · Speed Management

Which of these statements is true about brake fading?

  • A. Resting brakes does not bring back braking power
  • B. Brake fade is caused by drums getting too hot
  • C. Brake fade only affects new vehicles
  • D. Brake fade only happens with disc brakes
Question 4 of 25 · Speed Management

Brake fade results from:

  • A. Oversized brakes
  • B. Excessive heat from prolonged braking
  • C. Too much air pressure
  • D. Cold weather
Question 5 of 25 · Operation

When making a normal stop, what should you do?

  • A. Push the brake pedal down so you can stop at a safe place and remain in control
  • B. Pump the brakes
  • C. Use only the parking brake
  • D. Use only the trailer hand valve
Question 6 of 25 · Speed Management

Air brake lag distance at 55 mph on dry pavement adds about:

  • A. 12 feet to stopping distance
  • B. 32 feet to stopping distance
  • C. 50 feet to stopping distance
  • D. 100 feet to stopping distance
Question 7 of 25 · Compressor

Brake-system air pressure should build from 85 to 100 psi within:

  • A. 15 seconds in dual systems
  • B. 30 seconds in dual systems
  • C. 45 seconds in dual systems
  • D. 60 seconds in dual systems
Question 8 of 25 · Compressor

Which of these systems removes water and oil from compressed air?

  • A. Air dryer
  • B. Brake chamber
  • C. Slack adjuster
  • D. S-cam
Question 9 of 25 · ABS

Which is true about ABS?

  • A. It activates only on dry roads
  • B. It activates only when wheels are about to lock during heavy braking
  • C. It is the same as anti-skid
  • D. It eliminates the need for skid recovery
Question 10 of 25 · Inspection

When should you check the parking brake?

  • A. Whenever you start a trip
  • B. Once a month
  • C. Only at inspections
  • D. When the brake warning light is on
Question 11 of 25 · Inspection

How do you know that you have an air leak?

  • A. Pressure drops faster than allowable rate
  • B. You hear hissing
  • C. Both A and B
  • D. The brake pedal feels firm
Question 12 of 25 · System Basics

Which of these is NOT a part of the basic air brake system?

  • A. Air compressor
  • B. Air storage tanks
  • C. Hydraulic master cylinder
  • D. Foot brake valve
Question 13 of 25 · Tanks

Air brake equipped vehicles must have:

  • A. Only an emergency brake
  • B. A drain valve in each air tank
  • C. Hydraulic backup
  • D. Disc brakes only
Question 14 of 25 · Gauges

The supply pressure gauge tells you:

  • A. The pressure of brake fluid
  • B. How much air pressure is in the air tanks
  • C. The trailer brake pressure
  • D. The temperature of the brake
Question 15 of 25 · Parking

On a tractor with no trailer attached, the tractor parking brake control:

  • A. Will lock and unlock the front brakes
  • B. Will set or release the spring brakes on the tractor
  • C. Has no function
  • D. Operates only the trailer brakes
Question 16 of 25 · Foundation Brakes

What's the most common type of foundation brake found on heavy vehicles?

  • A. Disc brakes
  • B. Wedge drum brakes
  • C. S-cam drum brakes
  • D. Air-over-hydraulic
Question 17 of 25 · Combination Air

What does the trailer hand valve do?

  • A. Operates only the trailer brakes
  • B. Operates both the tractor and trailer brakes
  • C. Engages the parking brakes
  • D. Lowers the landing gear
Question 18 of 25 · ABS

If the ABS warning light comes on, you should:

  • A. Stop driving immediately
  • B. Continue, knowing brakes still work — but ABS may not
  • C. Pump the brakes constantly
  • D. Engage the trailer hand valve
Question 19 of 25 · Inspection

Which of the following must be checked before operating an air-braked vehicle?

  • A. Low air pressure warning signal
  • B. Spring brakes set automatically
  • C. Air leakage rate
  • D. All of the above
Question 20 of 25 · ABS

Which is correct about ABS-equipped vehicles?

  • A. You should never use ABS
  • B. ABS works only at high speeds
  • C. You should drive the same way as without ABS, except brake firmly without pumping in emergencies
  • D. ABS makes stopping distance shorter
Question 21 of 25 · Foundation Brakes

Brake drums (or discs) must not have cracks longer than:

  • A. 1/4 the width of the friction area
  • B. 1/2 the width of the friction area
  • C. 3/4 the width of the friction area
  • D. Anything is acceptable
Question 22 of 25 · Bobtail

What is bobtail braking?

  • A. Braking with no trailer attached, when the tractor brakes harder than usual
  • B. A type of trailer-only braking
  • C. Emergency braking on doubles
  • D. A way to test the parking brake
Question 23 of 25 · Compressor

What is the purpose of a one-way check valve?

  • A. Allow air to flow in one direction
  • B. Allow water to drain
  • C. Prevent the trailer from moving
  • D. Increase pressure in the supply tank
Question 24 of 25 · Spring Brakes

Where are spring brakes typically NOT found?

  • A. Front steering axle
  • B. Drive axles
  • C. Trailer axles
  • D. Tractor rear axles
Question 25 of 25 · Combination Air

When a tractor protection valve closes, it:

  • A. Opens the air supply to the trailer
  • B. Stops air from going to the trailer brakes
  • C. Causes the parking brake to release
  • D. Has no effect on the trailer
Back to Illinois

About the Air Brakes Test

The Air Brakes test covers air brake system parts (compressor, governor, reservoirs, drain valves, alcohol evaporator, safety valve, brake pedal, foundation brakes), dual air brake systems, inspecting air brakes, using air brakes (normal stops, emergency stops, parking brakes), and proper procedures for braking on downgrades. If you fail or skip the Air Brakes test, your CDL is restricted to vehicles without full air brake systems.

The Illinois Secretary of State — Driver Services administers this knowledge test as part of its commercial driver license program. To earn the Air Brakes Endorsement on your Illinois CDL, you need to score at least 20 out of 25 on the official version.

Topics covered on this practice test

How to use this practice test

  1. Read each question carefully. CDL questions are written precisely — small wording differences matter.
  2. Click "Show Answers & Explanations" only after answering every question. Don't peek mid-test.
  3. Read the explanation for every question, even ones you got right. The reasoning is more important than the answer.
  4. Repeat the test until you score 100%. The questions are deterministic per state, so you can track your improvement over multiple sessions.
  5. Move on to the other endorsement tests for Illinois until you're ready for the official exam.

Tips specific to the Air Brakes test

Air Brakes questions test your ability to identify components, follow inspection sequences, and respond to system failures. Memorize the cut-in and cut-out pressures, the low-pressure warning thresholds, the pressure ranges at which spring brakes apply, and the maximum allowable air-loss rates. Many questions have nearly-identical wording, so precision matters.

Other practice tests for Illinois