25 realistic Combination Vehicles practice questions for Delaware CDL applicants. Required for: Class A CDL (tractor-trailer combinations). Official test: 20 questions, 16 correct to pass.
Question 1 of 25 · Combination Air
When the trailer breaks away or loses air pressure, the trailer brakes should:
-
A.
Release
-
B.
Apply automatically
-
C.
Vibrate
-
D.
Disengage
Correct answer: B.
A loss of air should automatically apply the trailer brakes via the emergency system.
Question 2 of 25 · Coupling
When uncoupling, what is the final step?
-
A.
Lower the landing gear and disconnect electrical cord and air lines
-
B.
Drive forward immediately
-
C.
Set the parking brake on the tractor only
-
D.
Engage the trailer brakes only
Correct answer: A.
After raising the fifth wheel jaws and pulling forward, disconnect lines and lower landing gear.
Question 3 of 25 · Coupling
How can you keep a stiff coupling system from causing problems?
-
A.
Lubricate the fifth wheel
-
B.
Avoid backing under fast
-
C.
Inspect mounting bolts
-
D.
All of the above
Correct answer: D.
Lubricate, back slowly, and inspect mounting bolts to keep the coupling working safely.
Question 4 of 25 · Skids
Tractor jackknife occurs when:
-
A.
Drive wheels lose traction and skid
-
B.
The trailer wheels lock
-
C.
The trailer slides forward
-
D.
Steering wheels lock
Correct answer: A.
Drive wheels skidding cause tractor jackknife; trailer wheels skidding cause trailer jackknife.
Question 5 of 25 · Coupling
When coupling, what should you do after the fifth wheel locks onto the kingpin?
-
A.
Pull the tractor forward gently to make sure the kingpin is locked
-
B.
Disconnect the air lines
-
C.
Drive away immediately
-
D.
Release the trailer parking brake first
Correct answer: A.
Tug-test by gently pulling forward with the trailer brakes set to confirm the lock.
Question 6 of 25 · Following Distance
What is "rear-end collision" risk for combination vehicles?
-
A.
It is reduced when carrying long cargo
-
B.
They have a higher risk because of long stopping distances and rear blind spots
-
C.
They have no greater risk
-
D.
Only for empty rigs
Correct answer: B.
Long stopping distance and rear blind spots increase rear-end collision risk.
Question 7 of 25 · Coupling
What is the kingpin?
-
A.
A pin in the engine
-
B.
A vertical pin on the front of the trailer that locks into the fifth wheel
-
C.
A part of the air brake system
-
D.
A type of warning device
Correct answer: B.
The kingpin slides into the fifth wheel jaws to lock the trailer to the tractor.
Question 8 of 25 · Coupling
You should NEVER:
-
A.
Back under a trailer at an angle
-
B.
Inspect the fifth wheel
-
C.
Use the parking brake
-
D.
Tug-test the kingpin
Correct answer: A.
Backing at an angle can damage the kingpin or push the trailer sideways.
Question 9 of 25 · Cargo
What can cause a high center of gravity?
-
A.
Loading cargo too low
-
B.
Loading cargo too high or unevenly
-
C.
Driving too slowly
-
D.
Empty trailers
Correct answer: B.
Stacking cargo too high or loading unevenly raises the center of gravity and rollover risk.
Question 10 of 25 · Skids
What can cause a trailer skid in a combination vehicle?
-
A.
Locked trailer wheels and over-application of brakes
-
B.
Light loads on the trailer
-
C.
Tight steering at low speed
-
D.
High pressure in steering tires
Correct answer: A.
Locked trailer wheels cause trailer skid; reduce brake pressure to recover.
Question 11 of 25 · Skids
How can you correct a tractor jackknife?
-
A.
Apply the brakes harder
-
B.
Steer in the direction of the skid and accelerate gently
-
C.
Stop steering input
-
D.
Release the brakes and counter-steer
Correct answer: D.
Release the brakes to regain traction; counter-steer carefully to recover.
Question 12 of 25 · Combination Air
What is glad hands?
-
A.
Trailer doors
-
B.
Couplers used to join air lines from the tractor to the trailer
-
C.
Mirror brackets
-
D.
Brake levers
Correct answer: B.
Glad hands connect the service and emergency air lines between tractor and trailer.
Question 13 of 25 · Inspection
What is the proper way to test the parking brakes after coupling?
-
A.
Apply trailer parking brake and try to gently pull forward
-
B.
Drive at normal speed
-
C.
Apply foot brake repeatedly
-
D.
Disconnect glad hands
Correct answer: A.
A gentle pull forward with parking brakes set confirms holding power.
Question 14 of 25 · Inspection
Which of these is not a part of the trailer's electrical system?
-
A.
Lights
-
B.
Brake control
-
C.
Power line cord (pigtail)
-
D.
Hydraulic pump
Correct answer: D.
Hydraulic pumps are not part of standard trailer electrical systems on highway combinations.
Question 15 of 25 · Operation
Which of these is most important when driving with a trailer?
-
A.
Use the engine retarder constantly
-
B.
Use proper braking and signaling
-
C.
Drive at maximum speed limits
-
D.
Skip pre-trip checks if running late
Correct answer: B.
Proper braking and clear signaling are essential to safe combination driving.
Question 16 of 25 · Vehicle Dynamics
Which of these is true about the front trailer of a doubles or triples?
-
A.
It is less likely to overturn
-
B.
It is more stable
-
C.
It is more likely to overturn than the rear trailer
-
D.
It does not need brakes
Correct answer: A.
The front trailer in a combination is generally more stable than the rear trailer.
Question 17 of 25 · Vehicle Dynamics
What's the safest way to handle a tight turn with a long combination?
-
A.
Take it wide using both lanes if necessary
-
B.
Drive as fast as possible to maintain momentum
-
C.
Use the trailer hand valve
-
D.
Make a tight turn
Correct answer: A.
Take wider turns to avoid hitting curbs or other vehicles due to off-tracking.
Question 18 of 25 · Combination Air
Trailer brakes are required to be:
-
A.
Adjusted properly and matched to tractor brakes
-
B.
Stronger than tractor brakes
-
C.
Disengaged on level roads
-
D.
Off when empty
Correct answer: A.
Trailer brakes must be in proper adjustment and balance with tractor brakes.
Question 19 of 25 · Cargo
How do you know the trailer is properly loaded?
-
A.
Cargo is centered, balanced, and properly secured
-
B.
Cargo extends beyond the trailer ends
-
C.
Cargo is stacked unevenly
-
D.
Cargo is on top of the cab
Correct answer: A.
Centered, balanced, and secured loads handle predictably.
Question 20 of 25 · Bobtail
What happens if you bobtail (no trailer) and brake hard?
-
A.
You stop more quickly than loaded
-
B.
Drive wheels can lock and skid because there is little weight on them
-
C.
Vehicle handles like a loaded truck
-
D.
No special concerns
Correct answer: B.
Bobtailing leaves little weight on drive axles, increasing skid risk under hard braking.
Question 21 of 25 · Inspection
Which is true about gladhand seals?
-
A.
They should be replaced if cracked or damaged
-
B.
They never need replacement
-
C.
They are the same as electrical connections
-
D.
They are always made of metal
Correct answer: A.
Replace damaged or worn rubber seals to keep air from leaking at the gladhands.
Question 22 of 25 · Following Distance
How can you reduce risk of rear-end collisions?
-
A.
Maintain safe following distances and watch for slowing traffic
-
B.
Drive at the speed limit always
-
C.
Use mirrors only at night
-
D.
Avoid signaling
Correct answer: A.
Use safe following distances and watch ahead so you have time to slow down.
Question 23 of 25 · Skids
What should you do to recover from a trailer skid?
-
A.
Apply more brake pressure
-
B.
Release the brakes to allow trailer wheels to roll again
-
C.
Steer hard right
-
D.
Accelerate forward
Correct answer: B.
Release brakes to let trailer wheels roll, then steer to recover direction.
Question 24 of 25 · Inspection
You should inspect the rear of the trailer for:
-
A.
Cracked or missing lights
-
B.
Lights and reflectors are clean and operational
-
C.
Mud flap condition
-
D.
All of the above
Correct answer: D.
Check lights, reflectors, mud flaps, and license plate during pre-trip.
Question 25 of 25 · Skids
How can drivers avoid jackknifing?
-
A.
Brake gently and look ahead
-
B.
Adjust speed for road and weather
-
C.
Use ABS where equipped
-
D.
All of the above
Correct answer: D.
Smooth braking, appropriate speed, and ABS all reduce jackknife risk.
About the Combination Vehicles Test
The Combination Vehicles test covers driving combination vehicles safely, combination vehicle air brakes, antilock brake systems, coupling and uncoupling, and inspecting a combination vehicle. Combination vehicles are usually heavier, longer, and require more driving skill than single commercial vehicles. They are also more likely to roll over and jackknife.
The Delaware Division of Motor Vehicles administers this knowledge test as part of its commercial driver license program. To earn the Combination Vehicles on your Delaware CDL, you need to score at least 16 out of 20 on the official version.
Topics covered on this practice test
- Coupling: 5 questions
- Skids: 5 questions
- Inspection: 4 questions
- Combination Air: 3 questions
- Following Distance: 2 questions
- Cargo: 2 questions
- Vehicle Dynamics: 2 questions
- Operation: 1 question
- Bobtail: 1 question
How to use this practice test
- Read each question carefully. CDL questions are written precisely — small wording differences matter.
- Click "Show Answers & Explanations" only after answering every question. Don't peek mid-test.
- Read the explanation for every question, even ones you got right. The reasoning is more important than the answer.
- Repeat the test until you score 100%. The questions are deterministic per state, so you can track your improvement over multiple sessions.
- Move on to the other endorsement tests for Delaware until you're ready for the official exam.
Tips specific to the Combination Vehicles test
Combination Vehicles questions cover off-tracking, jackknifing, coupling and uncoupling, the fifth wheel, kingpin, glad hands, landing gear, and the special air-brake considerations for tractor-trailer combinations. Expect detailed step-by-step coupling questions.