Montana Air Brakes CDL Practice Test
25 realistic Air Brakes practice questions for Montana CDL applicants. Required for: Vehicles equipped with air brake systems. Official test: 25 questions, 20 correct to pass.
Question 1 of 25 · Inspection
Which of the following must be checked before operating an air-braked vehicle?
-
A.
Low air pressure warning signal
-
B.
Spring brakes set automatically
-
C.
Air leakage rate
-
D.
All of the above
Correct answer: D.
All of these are required pre-trip air brake checks.
Question 2 of 25 · Speed Management
Air brake lag distance at 55 mph on dry pavement adds about:
-
A.
12 feet to stopping distance
-
B.
32 feet to stopping distance
-
C.
50 feet to stopping distance
-
D.
100 feet to stopping distance
Correct answer: B.
Air brake systems have a lag of about 0.4 seconds, adding roughly 32 feet at 55 mph.
Question 3 of 25 · ABS
What is the proper procedure for an air brake stop in a vehicle equipped with ABS?
-
A.
Pump the brakes
-
B.
Press the brake pedal firmly and steadily; let ABS work
-
C.
Disengage ABS first
-
D.
Apply the parking brake
Correct answer: B.
With ABS, brake firmly and steadily. ABS prevents wheel lockup automatically.
Question 4 of 25 · Parking
On a tractor with no trailer attached, the tractor parking brake control:
-
A.
Will lock and unlock the front brakes
-
B.
Will set or release the spring brakes on the tractor
-
C.
Has no function
-
D.
Operates only the trailer brakes
Correct answer: B.
The yellow diamond control sets and releases the tractor parking (spring) brakes.
Question 5 of 25 · Combination Air
When a tractor protection valve closes, it:
-
A.
Opens the air supply to the trailer
-
B.
Stops air from going to the trailer brakes
-
C.
Causes the parking brake to release
-
D.
Has no effect on the trailer
Correct answer: B.
When closed, it stops airflow to the trailer and applies trailer emergency brakes.
Question 6 of 25 · Operation
When making a normal stop, what should you do?
-
A.
Push the brake pedal down so you can stop at a safe place and remain in control
-
B.
Pump the brakes
-
C.
Use only the parking brake
-
D.
Use only the trailer hand valve
Correct answer: A.
Apply pressure progressively to come to a smooth, safe stop while maintaining control.
Question 7 of 25 · Tanks
Air brake equipped vehicles must have:
-
A.
Only an emergency brake
-
B.
A drain valve in each air tank
-
C.
Hydraulic backup
-
D.
Disc brakes only
Correct answer: B.
Each air tank has a drain valve to remove water and oil that collect in the tank.
Question 8 of 25 · Tanks
Why must air tanks be drained?
-
A.
To remove fuel from the system
-
B.
To remove water and compressor oil that can damage the brakes
-
C.
To inspect the tanks
-
D.
To increase pressure
Correct answer: B.
Water and oil collect in tanks. They damage seals and can freeze in cold weather.
Question 9 of 25 · Spring Brakes
If your vehicle has dual parking control valves, you can use pressure from a separate tank to:
-
A.
Charge the trailer brakes
-
B.
Release the spring brakes to move a short distance if the main system loses air
-
C.
Operate the steering
-
D.
Power the air horn
Correct answer: B.
Dual parking control valves let you temporarily release spring brakes from a backup tank.
Question 10 of 25 · Tanks
When should you drain the air tanks?
-
A.
Once a week
-
B.
Only when the warning light is on
-
C.
At the end of each working day
-
D.
Once a month
Correct answer: C.
Drain tanks completely at the end of each working day to remove water and oil.
Question 11 of 25 · ABS
If the ABS warning light comes on, you should:
-
A.
Stop driving immediately
-
B.
Continue, knowing brakes still work — but ABS may not
-
C.
Pump the brakes constantly
-
D.
Engage the trailer hand valve
Correct answer: B.
You still have normal braking; only the ABS function may be off. Get it fixed soon.
Question 12 of 25 · Spring Brakes
What does a "spring brake" mean?
-
A.
A brake that operates only in spring weather
-
B.
A mechanical brake that uses powerful springs to apply the brake when air pressure is lost
-
C.
A specific kind of disc brake
-
D.
A backup hydraulic brake
Correct answer: B.
Spring brakes use powerful coil springs to apply the brakes when air pressure is lost.
Question 13 of 25 · Inspection
How do you test the low pressure warning signal?
-
A.
With the engine off, pump the brake pedal until the signal activates (must come on at 60 psi or above)
-
B.
Drive the vehicle to lose pressure
-
C.
Open the air tank drain valve briefly
-
D.
Push the parking brake control
Correct answer: A.
Pump the brake to lower pressure; warning must come on at 60 psi or higher.
Question 14 of 25 · Compressor
What is the purpose of a one-way check valve?
-
A.
Allow air to flow in one direction
-
B.
Allow water to drain
-
C.
Prevent the trailer from moving
-
D.
Increase pressure in the supply tank
Correct answer: A.
It permits airflow in one direction only — protecting the system if the compressor fails.
Question 15 of 25 · Warning Devices
The low air pressure warning device must come on when air pressure in the service tanks falls below:
-
A.
80 psi
-
B.
60 psi
-
C.
50 psi or 1/2 the compressor governor cut-out pressure
-
D.
20 psi
Correct answer: C.
Low pressure warnings activate at 60 psi or less (or half the cut-out pressure on older vehicles).
Question 16 of 25 · System Basics
Which of these is NOT a part of the basic air brake system?
-
A.
Air compressor
-
B.
Air storage tanks
-
C.
Hydraulic master cylinder
-
D.
Foot brake valve
Correct answer: C.
Hydraulic master cylinders belong to hydraulic brake systems, not air brake systems.
Question 17 of 25 · Bobtail
What is bobtail braking?
-
A.
Braking with no trailer attached, when the tractor brakes harder than usual
-
B.
A type of trailer-only braking
-
C.
Emergency braking on doubles
-
D.
A way to test the parking brake
Correct answer: A.
A bobtail tractor (without a trailer) brakes hard because it has less weight on the drive axles.
Question 18 of 25 · Compressor
What is the purpose of an alcohol evaporator?
-
A.
Reduce alcohol in the driver's system
-
B.
Reduce risk of frozen brake valves and lines in cold weather
-
C.
Improve fuel economy
-
D.
Lubricate the air compressor
Correct answer: B.
Alcohol injected into the air system reduces freeze-up risk in cold conditions.
Question 19 of 25 · System Basics
Air brake systems combine three different braking systems. They are:
-
A.
Service, parking, and emergency brakes
-
B.
Hydraulic, parking, and emergency brakes
-
C.
Front, rear, and trailer brakes
-
D.
Disc, drum, and parking brakes
Correct answer: A.
The three are: the service brake, the parking brake, and the emergency brake.
Question 20 of 25 · Inspection
When checking air brake adjustment, the engine should be:
-
A.
Running at idle
-
B.
Off with the brakes released
-
C.
Running at high RPM
-
D.
Off with the brakes applied
Correct answer: B.
Inspect with the engine off and the brakes released so chambers are not pressurized.
Question 21 of 25 · Inspection
How can you check the slack adjusters?
-
A.
Pull hard on each slack adjuster — they should not move more than about 1 inch
-
B.
Listen for air leaks at each chamber
-
C.
Watch the brake light flash
-
D.
Look at the brake pedal travel
Correct answer: A.
Pulling hard, slack adjusters should not move more than about 1 inch where the push rod attaches.
Question 22 of 25 · Spring Brakes
Modulating control valves do what?
-
A.
Drain water from tanks
-
B.
Apply spring brakes gradually using a hand control
-
C.
Open the trailer supply line
-
D.
Switch to emergency brakes
Correct answer: B.
Modulating valves let you apply the spring brakes gradually rather than all at once.
Question 23 of 25 · Inspection
How much air pressure (psi) loss is allowed per minute for single vehicles with the engine off and brakes released?
-
A.
Up to 1 psi
-
B.
Up to 2 psi
-
C.
Up to 3 psi
-
D.
Up to 4 psi
Correct answer: B.
Single vehicles allow up to 2 psi per minute with brakes released; up to 3 psi with brakes applied.
Question 24 of 25 · Speed Management
Total stopping distance for an air-braked vehicle is made up of:
-
A.
Perception distance + reaction distance + brake lag distance + braking distance
-
B.
Just the braking distance
-
C.
Reaction distance only
-
D.
Brake lag distance only
Correct answer: A.
It is the sum of perception distance, reaction distance, brake lag distance, and braking distance.
Question 25 of 25 · Tanks
What is the safety valve set to open at?
-
A.
100 psi
-
B.
125 psi
-
C.
150 psi
-
D.
180 psi
Correct answer: C.
The safety valve is normally set to open at 150 psi to protect the system from over-pressurization.
About the Air Brakes Test
The Air Brakes test covers air brake system parts (compressor, governor, reservoirs, drain valves, alcohol evaporator, safety valve, brake pedal, foundation brakes), dual air brake systems, inspecting air brakes, using air brakes (normal stops, emergency stops, parking brakes), and proper procedures for braking on downgrades. If you fail or skip the Air Brakes test, your CDL is restricted to vehicles without full air brake systems.
The Montana Motor Vehicle Division administers this knowledge test as part of its commercial driver license program. To earn the Air Brakes Endorsement on your Montana CDL, you need to score at least 20 out of 25 on the official version.
Topics covered on this practice test
- Inspection: 5 questions
- Tanks: 4 questions
- Spring Brakes: 3 questions
- Speed Management: 2 questions
- ABS: 2 questions
- Compressor: 2 questions
- System Basics: 2 questions
- Parking: 1 question
- Combination Air: 1 question
- Operation: 1 question
- Warning Devices: 1 question
- Bobtail: 1 question
How to use this practice test
- Read each question carefully. CDL questions are written precisely — small wording differences matter.
- Click "Show Answers & Explanations" only after answering every question. Don't peek mid-test.
- Read the explanation for every question, even ones you got right. The reasoning is more important than the answer.
- Repeat the test until you score 100%. The questions are deterministic per state, so you can track your improvement over multiple sessions.
- Move on to the other endorsement tests for Montana until you're ready for the official exam.
Tips specific to the Air Brakes test
Air Brakes questions test your ability to identify components, follow inspection sequences, and respond to system failures. Memorize the cut-in and cut-out pressures, the low-pressure warning thresholds, the pressure ranges at which spring brakes apply, and the maximum allowable air-loss rates. Many questions have nearly-identical wording, so precision matters.
Other practice tests for Montana