25 realistic Combination Vehicles practice questions for New Hampshire CDL applicants. Required for: Class A CDL (tractor-trailer combinations). Official test: 20 questions, 16 correct to pass.
Question 1 of 25 · Bobtail
What happens if you bobtail (no trailer) and brake hard?
-
A.
You stop more quickly than loaded
-
B.
Drive wheels can lock and skid because there is little weight on them
-
C.
Vehicle handles like a loaded truck
-
D.
No special concerns
Correct answer: B.
Bobtailing leaves little weight on drive axles, increasing skid risk under hard braking.
Question 2 of 25 · Coupling
What are landing gear used for?
-
A.
Supporting the front of the trailer when uncoupled
-
B.
Steering the trailer
-
C.
Powering the trailer brakes
-
D.
Lighting the trailer
Correct answer: A.
Landing gear holds up the trailer when it is not connected to a tractor.
Question 3 of 25 · Following Distance
How can you reduce risk of rear-end collisions?
-
A.
Maintain safe following distances and watch for slowing traffic
-
B.
Drive at the speed limit always
-
C.
Use mirrors only at night
-
D.
Avoid signaling
Correct answer: A.
Use safe following distances and watch ahead so you have time to slow down.
Question 4 of 25 · Combination Air
When the trailer breaks away or loses air pressure, the trailer brakes should:
-
A.
Release
-
B.
Apply automatically
-
C.
Vibrate
-
D.
Disengage
Correct answer: B.
A loss of air should automatically apply the trailer brakes via the emergency system.
Question 5 of 25 · Coupling
Which is true about pulling away after coupling?
-
A.
Test that the kingpin is locked by gently pulling forward against the trailer brakes
-
B.
Pull away as quickly as possible
-
C.
Lower the landing gear before pulling away
-
D.
Disconnect the air lines first
Correct answer: A.
A pull-test confirms the kingpin is locked before driving away.
Question 6 of 25 · Skids
How can you correct a tractor jackknife?
-
A.
Apply the brakes harder
-
B.
Steer in the direction of the skid and accelerate gently
-
C.
Stop steering input
-
D.
Release the brakes and counter-steer
Correct answer: D.
Release the brakes to regain traction; counter-steer carefully to recover.
Question 7 of 25 · Combination Air
Trailer brakes are required to be:
-
A.
Adjusted properly and matched to tractor brakes
-
B.
Stronger than tractor brakes
-
C.
Disengaged on level roads
-
D.
Off when empty
Correct answer: A.
Trailer brakes must be in proper adjustment and balance with tractor brakes.
Question 8 of 25 · Cargo
What can cause a high center of gravity?
-
A.
Loading cargo too low
-
B.
Loading cargo too high or unevenly
-
C.
Driving too slowly
-
D.
Empty trailers
Correct answer: B.
Stacking cargo too high or loading unevenly raises the center of gravity and rollover risk.
Question 9 of 25 · Vehicle Dynamics
When you turn suddenly with a high center of gravity, the trailer can:
-
A.
Roll over
-
B.
Stop more quickly
-
C.
Track better
-
D.
Reduce fuel use
Correct answer: A.
High centers of gravity make trailers prone to rollover during sharp turns.
Question 10 of 25 · Coupling
When you finish coupling, the air lines should be:
-
A.
Connected to the proper glad hands and supported off the catwalk and the deck plate
-
B.
Coiled tightly on top of the trailer
-
C.
Loose so they can move freely
-
D.
Disconnected
Correct answer: A.
Air lines must be connected and supported off the deck so they don't snag or wear.
Question 11 of 25 · Inspection
You should inspect the rear of the trailer for:
-
A.
Cracked or missing lights
-
B.
Lights and reflectors are clean and operational
-
C.
Mud flap condition
-
D.
All of the above
Correct answer: D.
Check lights, reflectors, mud flaps, and license plate during pre-trip.
Question 12 of 25 · Inspection
When checking the trailer air supply, you should:
-
A.
Charge the trailer with air, then disconnect the supply hose to test trailer emergency brakes
-
B.
Pump the brakes
-
C.
Disconnect the trailer power cord
-
D.
Open the trailer service line manually
Correct answer: A.
Disconnecting the supply line tests that the trailer emergency brakes apply automatically.
Question 13 of 25 · Inspection
Which is true about gladhand seals?
-
A.
They should be replaced if cracked or damaged
-
B.
They never need replacement
-
C.
They are the same as electrical connections
-
D.
They are always made of metal
Correct answer: A.
Replace damaged or worn rubber seals to keep air from leaking at the gladhands.
Question 14 of 25 · Skids
Tractor jackknife occurs when:
-
A.
Drive wheels lose traction and skid
-
B.
The trailer wheels lock
-
C.
The trailer slides forward
-
D.
Steering wheels lock
Correct answer: A.
Drive wheels skidding cause tractor jackknife; trailer wheels skidding cause trailer jackknife.
Question 15 of 25 · Combination Air
What should the tractor protection valve do?
-
A.
Keep tractor air supply if trailer breaks away or develops a major leak
-
B.
Set the trailer parking brake on a hill
-
C.
Apply trailer brakes during a normal stop
-
D.
Disconnect the trailer
Correct answer: A.
It protects the tractor air supply by closing if a major air loss occurs.
Question 16 of 25 · Coupling
What is the kingpin?
-
A.
A pin in the engine
-
B.
A vertical pin on the front of the trailer that locks into the fifth wheel
-
C.
A part of the air brake system
-
D.
A type of warning device
Correct answer: B.
The kingpin slides into the fifth wheel jaws to lock the trailer to the tractor.
Question 17 of 25 · Vehicle Dynamics
What's the safest way to handle a tight turn with a long combination?
-
A.
Take it wide using both lanes if necessary
-
B.
Drive as fast as possible to maintain momentum
-
C.
Use the trailer hand valve
-
D.
Make a tight turn
Correct answer: A.
Take wider turns to avoid hitting curbs or other vehicles due to off-tracking.
Question 18 of 25 · Inspection
When inspecting your trailer's wheels, what should you look for?
-
A.
Loose or missing nuts
-
B.
Cracked or broken wheel rims
-
C.
Bent or broken studs
-
D.
All of the above
Correct answer: D.
Inspect for loose nuts, cracks, bent studs, and other defects on every pre-trip.
Question 19 of 25 · Vehicle Dynamics
Which of these is true about the front trailer of a doubles or triples?
-
A.
It is less likely to overturn
-
B.
It is more stable
-
C.
It is more likely to overturn than the rear trailer
-
D.
It does not need brakes
Correct answer: A.
The front trailer in a combination is generally more stable than the rear trailer.
Question 20 of 25 · Speed Management
What is the most common cause of fatal crashes for combination vehicles?
-
A.
Loss of control due to speed too fast for conditions
-
B.
Engine failure
-
C.
Tire blowouts
-
D.
Mechanical defects only
Correct answer: A.
Driving too fast for conditions is the leading cause of serious crashes.
Question 21 of 25 · Skids
What is the result of a "trailer jackknife"?
-
A.
Trailer continues straight ahead
-
B.
Trailer swings out and tractor pivots
-
C.
Trailer comes to a quick safe stop
-
D.
Trailer disengages
Correct answer: B.
In a trailer jackknife, the trailer swings out, often into adjacent lanes.
Question 22 of 25 · Vehicle Dynamics
Empty trucks have what kind of stopping distance compared to fully loaded ones?
-
A.
Shorter
-
B.
Same
-
C.
Longer
-
D.
Half
Correct answer: C.
Empty rigs have less traction on drive axles and require greater stopping distance.
Question 23 of 25 · Coupling
You should NEVER:
-
A.
Back under a trailer at an angle
-
B.
Inspect the fifth wheel
-
C.
Use the parking brake
-
D.
Tug-test the kingpin
Correct answer: A.
Backing at an angle can damage the kingpin or push the trailer sideways.
Question 24 of 25 · Backing
Which is correct about backing a tractor-trailer?
-
A.
Steer in the same direction you want the trailer to go
-
B.
Steer in the opposite direction you want the trailer to go
-
C.
Use the throttle to back
-
D.
Back as fast as possible
Correct answer: B.
When backing, turn the steering wheel opposite to the direction you want the trailer to move.
Question 25 of 25 · CDL Rules
Which is true about long combination vehicles (LCVs)?
-
A.
They are easier to maneuver in tight spaces
-
B.
They require additional driver training and special permits
-
C.
They handle the same as single trailers
-
D.
They never require special routes
Correct answer: B.
LCVs need extra training, certifications, and often follow restricted routes.
About the Combination Vehicles Test
The Combination Vehicles test covers driving combination vehicles safely, combination vehicle air brakes, antilock brake systems, coupling and uncoupling, and inspecting a combination vehicle. Combination vehicles are usually heavier, longer, and require more driving skill than single commercial vehicles. They are also more likely to roll over and jackknife.
The New Hampshire Division of Motor Vehicles administers this knowledge test as part of its commercial driver license program. To earn the Combination Vehicles on your New Hampshire CDL, you need to score at least 16 out of 20 on the official version.
Topics covered on this practice test
- Coupling: 5 questions
- Vehicle Dynamics: 4 questions
- Inspection: 4 questions
- Combination Air: 3 questions
- Skids: 3 questions
- Bobtail: 1 question
- Following Distance: 1 question
- Cargo: 1 question
- Speed Management: 1 question
- Backing: 1 question
- CDL Rules: 1 question
How to use this practice test
- Read each question carefully. CDL questions are written precisely — small wording differences matter.
- Click "Show Answers & Explanations" only after answering every question. Don't peek mid-test.
- Read the explanation for every question, even ones you got right. The reasoning is more important than the answer.
- Repeat the test until you score 100%. The questions are deterministic per state, so you can track your improvement over multiple sessions.
- Move on to the other endorsement tests for New Hampshire until you're ready for the official exam.
Tips specific to the Combination Vehicles test
Combination Vehicles questions cover off-tracking, jackknifing, coupling and uncoupling, the fifth wheel, kingpin, glad hands, landing gear, and the special air-brake considerations for tractor-trailer combinations. Expect detailed step-by-step coupling questions.