25 realistic Air Brakes practice questions for Virginia CDL applicants. Required for: Vehicles equipped with air brake systems. Official test: 25 questions, 20 correct to pass.
Question 1 of 25 · System Basics
Air brakes use compressed air to:
-
A.
Lubricate the wheels
-
B.
Make the brakes work
-
C.
Cool the engine
-
D.
Increase fuel pressure
Correct answer: B.
Compressed air is the working fluid that applies the brakes in an air brake system.
Question 2 of 25 · Combination Air
What does the trailer hand valve do?
-
A.
Operates only the trailer brakes
-
B.
Operates both the tractor and trailer brakes
-
C.
Engages the parking brakes
-
D.
Lowers the landing gear
Correct answer: A.
The hand valve (trolley valve) controls only the trailer service brakes.
Question 3 of 25 · Emergency Maneuvers
Stab braking includes which of these steps?
-
A.
Apply brakes fully, release when wheels lock, reapply when wheels begin rolling
-
B.
Apply brakes lightly until they fade
-
C.
Pump the brakes rapidly
-
D.
Apply the parking brake repeatedly
Correct answer: A.
Stab braking: full application, release on lockup, reapply when wheels turn again.
Question 4 of 25 · System Basics
Which of the following is NOT in the air brake system?
-
A.
Brake chambers
-
B.
Slack adjusters
-
C.
S-cam
-
D.
Hydraulic master cylinder
Correct answer: D.
Hydraulic master cylinders are part of hydraulic systems, not air brake systems.
Question 5 of 25 · ABS
What is the proper procedure for an air brake stop in a vehicle equipped with ABS?
-
A.
Pump the brakes
-
B.
Press the brake pedal firmly and steadily; let ABS work
-
C.
Disengage ABS first
-
D.
Apply the parking brake
Correct answer: B.
With ABS, brake firmly and steadily. ABS prevents wheel lockup automatically.
Question 6 of 25 · Spring Brakes
What does a "spring brake" mean?
-
A.
A brake that operates only in spring weather
-
B.
A mechanical brake that uses powerful springs to apply the brake when air pressure is lost
-
C.
A specific kind of disc brake
-
D.
A backup hydraulic brake
Correct answer: B.
Spring brakes use powerful coil springs to apply the brakes when air pressure is lost.
Question 7 of 25 · Speed Management
Air brake lag is:
-
A.
The time required for the brakes to apply after the pedal is pressed
-
B.
The amount of free play in the brake pedal
-
C.
The distance traveled before the brakes release
-
D.
The time to drain air tanks
Correct answer: A.
Lag is the time between pressing the pedal and the brakes actually applying — about 0.4 seconds.
Question 8 of 25 · Spring Brakes
Spring brakes:
-
A.
Are released by air pressure
-
B.
Are applied by air pressure
-
C.
Should be tested by pumping the brake pedal
-
D.
Are only on the trailer
Correct answer: A.
Spring brakes are held off (released) by air pressure. When pressure drops, the springs apply the brakes.
Question 9 of 25 · Compressor
Brake-system air pressure should build from 85 to 100 psi within:
-
A.
15 seconds in dual systems
-
B.
30 seconds in dual systems
-
C.
45 seconds in dual systems
-
D.
60 seconds in dual systems
Correct answer: C.
Build-up time should be within 45 seconds in dual air systems.
Question 10 of 25 · Operation
When making a normal stop, what should you do?
-
A.
Push the brake pedal down so you can stop at a safe place and remain in control
-
B.
Pump the brakes
-
C.
Use only the parking brake
-
D.
Use only the trailer hand valve
Correct answer: A.
Apply pressure progressively to come to a smooth, safe stop while maintaining control.
Question 11 of 25 · Compressor
Which of these systems removes water and oil from compressed air?
-
A.
Air dryer
-
B.
Brake chamber
-
C.
Slack adjuster
-
D.
S-cam
Correct answer: A.
The air dryer removes moisture and oil from the air before it reaches the storage tanks.
Question 12 of 25 · Inspection
How can you check the slack adjusters?
-
A.
Pull hard on each slack adjuster — they should not move more than about 1 inch
-
B.
Listen for air leaks at each chamber
-
C.
Watch the brake light flash
-
D.
Look at the brake pedal travel
Correct answer: A.
Pulling hard, slack adjusters should not move more than about 1 inch where the push rod attaches.
Question 13 of 25 · Emergency Maneuvers
Which of these statements is true about emergency braking?
-
A.
Pumping the brakes is always best
-
B.
Stab braking is for non-ABS vehicles in emergencies
-
C.
You should brake harder than necessary
-
D.
Stab braking is the same as pumping
Correct answer: B.
Stab braking applies to non-ABS systems: full application until lockup, then release.
Question 14 of 25 · System Basics
Air brake systems combine three different braking systems. They are:
-
A.
Service, parking, and emergency brakes
-
B.
Hydraulic, parking, and emergency brakes
-
C.
Front, rear, and trailer brakes
-
D.
Disc, drum, and parking brakes
Correct answer: A.
The three are: the service brake, the parking brake, and the emergency brake.
Question 15 of 25 · Inspection
How much air pressure (psi) loss is allowed per minute for combination vehicles with the engine off and brakes released?
-
A.
Up to 1 psi
-
B.
Up to 2 psi
-
C.
Up to 3 psi
-
D.
Up to 4 psi
Correct answer: B.
Combination vehicles allow up to 3 psi loss per minute with brakes released; with brakes applied, up to 4 psi.
Question 16 of 25 · Inspection
How much air pressure (psi) loss is allowed per minute for single vehicles with the engine off and brakes released?
-
A.
Up to 1 psi
-
B.
Up to 2 psi
-
C.
Up to 3 psi
-
D.
Up to 4 psi
Correct answer: B.
Single vehicles allow up to 2 psi per minute with brakes released; up to 3 psi with brakes applied.
Question 17 of 25 · Speed Management
Which of these statements is true about brake fading?
-
A.
Resting brakes does not bring back braking power
-
B.
Brake fade is caused by drums getting too hot
-
C.
Brake fade only affects new vehicles
-
D.
Brake fade only happens with disc brakes
Correct answer: B.
Brake fade results from overheated drums or discs reducing friction and braking ability.
Question 18 of 25 · Inspection
How do you test the low pressure warning signal?
-
A.
With the engine off, pump the brake pedal until the signal activates (must come on at 60 psi or above)
-
B.
Drive the vehicle to lose pressure
-
C.
Open the air tank drain valve briefly
-
D.
Push the parking brake control
Correct answer: A.
Pump the brake to lower pressure; warning must come on at 60 psi or higher.
Question 19 of 25 · Parking
On a tractor with no trailer attached, the tractor parking brake control:
-
A.
Will lock and unlock the front brakes
-
B.
Will set or release the spring brakes on the tractor
-
C.
Has no function
-
D.
Operates only the trailer brakes
Correct answer: B.
The yellow diamond control sets and releases the tractor parking (spring) brakes.
Question 20 of 25 · Speed Management
Why is it important not to over-apply the brakes?
-
A.
Brakes can overheat and fade
-
B.
Brakes will lock and skid
-
C.
You may lose control of the vehicle
-
D.
All of the above
Correct answer: D.
Over-application leads to fade, lockup, skidding, and loss of control.
Question 21 of 25 · Parking
You should never use the trailer hand valve to park because:
-
A.
It is not strong enough
-
B.
The air could leak out, releasing the brakes
-
C.
It only applies the front brakes
-
D.
It is not connected to the trailer
Correct answer: B.
If air leaks out, the brakes release. Always use the parking brake to park.
Question 22 of 25 · Spring Brakes
If your vehicle has dual parking control valves, you can use pressure from a separate tank to:
-
A.
Charge the trailer brakes
-
B.
Release the spring brakes to move a short distance if the main system loses air
-
C.
Operate the steering
-
D.
Power the air horn
Correct answer: B.
Dual parking control valves let you temporarily release spring brakes from a backup tank.
Question 23 of 25 · Parking
Why should you use chocks?
-
A.
When parking on a hill
-
B.
On level ground when leaving the vehicle
-
C.
Whenever brakes might fail or it's required by company policy or law
-
D.
All of the above
Correct answer: D.
Chocks should be used when required to prevent vehicle movement.
Question 24 of 25 · Inspection
How do you know that you have an air leak?
-
A.
Pressure drops faster than allowable rate
-
B.
You hear hissing
-
C.
Both A and B
-
D.
The brake pedal feels firm
Correct answer: C.
Pressure dropping faster than allowed and audible hissing both indicate leaks.
Question 25 of 25 · Operation
When the brake pedal is pushed harder, what happens?
-
A.
Brake pedal must be pumped to release
-
B.
More air goes to the brakes; less foot pressure releases air
-
C.
It locks the brakes permanently
-
D.
The brakes do not respond
Correct answer: B.
The harder you push, the more air pressure is sent to the brake chambers.
About the Air Brakes Test
The Air Brakes test covers air brake system parts (compressor, governor, reservoirs, drain valves, alcohol evaporator, safety valve, brake pedal, foundation brakes), dual air brake systems, inspecting air brakes, using air brakes (normal stops, emergency stops, parking brakes), and proper procedures for braking on downgrades. If you fail or skip the Air Brakes test, your CDL is restricted to vehicles without full air brake systems.
The Virginia Department of Motor Vehicles administers this knowledge test as part of its commercial driver license program. To earn the Air Brakes Endorsement on your Virginia CDL, you need to score at least 20 out of 25 on the official version.
Topics covered on this practice test
- Inspection: 5 questions
- System Basics: 3 questions
- Spring Brakes: 3 questions
- Speed Management: 3 questions
- Parking: 3 questions
- Emergency Maneuvers: 2 questions
- Compressor: 2 questions
- Operation: 2 questions
- Combination Air: 1 question
- ABS: 1 question
How to use this practice test
- Read each question carefully. CDL questions are written precisely — small wording differences matter.
- Click "Show Answers & Explanations" only after answering every question. Don't peek mid-test.
- Read the explanation for every question, even ones you got right. The reasoning is more important than the answer.
- Repeat the test until you score 100%. The questions are deterministic per state, so you can track your improvement over multiple sessions.
- Move on to the other endorsement tests for Virginia until you're ready for the official exam.
Tips specific to the Air Brakes test
Air Brakes questions test your ability to identify components, follow inspection sequences, and respond to system failures. Memorize the cut-in and cut-out pressures, the low-pressure warning thresholds, the pressure ranges at which spring brakes apply, and the maximum allowable air-loss rates. Many questions have nearly-identical wording, so precision matters.