25 realistic Air Brakes practice questions for Missouri CDL applicants. Required for: Vehicles equipped with air brake systems. Official test: 25 questions, 20 correct to pass.
Question 1 of 25 · Spring Brakes
Modulating control valves do what?
-
A.
Drain water from tanks
-
B.
Apply spring brakes gradually using a hand control
-
C.
Open the trailer supply line
-
D.
Switch to emergency brakes
Correct answer: B.
Modulating valves let you apply the spring brakes gradually rather than all at once.
Question 2 of 25 · Spring Brakes
What does a "spring brake" mean?
-
A.
A brake that operates only in spring weather
-
B.
A mechanical brake that uses powerful springs to apply the brake when air pressure is lost
-
C.
A specific kind of disc brake
-
D.
A backup hydraulic brake
Correct answer: B.
Spring brakes use powerful coil springs to apply the brakes when air pressure is lost.
Question 3 of 25 · Compressor
What is the purpose of a one-way check valve?
-
A.
Allow air to flow in one direction
-
B.
Allow water to drain
-
C.
Prevent the trailer from moving
-
D.
Increase pressure in the supply tank
Correct answer: A.
It permits airflow in one direction only — protecting the system if the compressor fails.
Question 4 of 25 · Warning Devices
The low air pressure warning device must come on when air pressure in the service tanks falls below:
-
A.
80 psi
-
B.
60 psi
-
C.
50 psi or 1/2 the compressor governor cut-out pressure
-
D.
20 psi
Correct answer: C.
Low pressure warnings activate at 60 psi or less (or half the cut-out pressure on older vehicles).
Question 5 of 25 · Tanks
What is the safety valve set to open at?
-
A.
100 psi
-
B.
125 psi
-
C.
150 psi
-
D.
180 psi
Correct answer: C.
The safety valve is normally set to open at 150 psi to protect the system from over-pressurization.
Question 6 of 25 · Operation
When making a normal stop, what should you do?
-
A.
Push the brake pedal down so you can stop at a safe place and remain in control
-
B.
Pump the brakes
-
C.
Use only the parking brake
-
D.
Use only the trailer hand valve
Correct answer: A.
Apply pressure progressively to come to a smooth, safe stop while maintaining control.
Question 7 of 25 · Spring Brakes
Where are spring brakes typically NOT found?
-
A.
Front steering axle
-
B.
Drive axles
-
C.
Trailer axles
-
D.
Tractor rear axles
Correct answer: A.
Spring brakes are found on drive axles and trailer axles, not normally on the steering axle.
Question 8 of 25 · Speed Management
Total stopping distance for an air-braked vehicle is made up of:
-
A.
Perception distance + reaction distance + brake lag distance + braking distance
-
B.
Just the braking distance
-
C.
Reaction distance only
-
D.
Brake lag distance only
Correct answer: A.
It is the sum of perception distance, reaction distance, brake lag distance, and braking distance.
Question 9 of 25 · Compressor
The air compressor governor controls:
-
A.
When the air compressor will pump air into the storage tanks
-
B.
When the brakes are applied
-
C.
When emergency brakes engage
-
D.
How fast the air compressor turns
Correct answer: A.
The governor cuts the compressor in and out to keep the system within its operating pressure range.
Question 10 of 25 · Inspection
How much air pressure (psi) loss is allowed per minute for single vehicles with the engine off and brakes released?
-
A.
Up to 1 psi
-
B.
Up to 2 psi
-
C.
Up to 3 psi
-
D.
Up to 4 psi
Correct answer: B.
Single vehicles allow up to 2 psi per minute with brakes released; up to 3 psi with brakes applied.
Question 11 of 25 · Combination Air
What does the trailer hand valve do?
-
A.
Operates only the trailer brakes
-
B.
Operates both the tractor and trailer brakes
-
C.
Engages the parking brakes
-
D.
Lowers the landing gear
Correct answer: A.
The hand valve (trolley valve) controls only the trailer service brakes.
Question 12 of 25 · ABS
Which is correct about ABS-equipped vehicles?
-
A.
You should never use ABS
-
B.
ABS works only at high speeds
-
C.
You should drive the same way as without ABS, except brake firmly without pumping in emergencies
-
D.
ABS makes stopping distance shorter
Correct answer: C.
Drive normally; in emergencies, brake firmly and let ABS prevent lockup. ABS doesn't shorten stopping distance.
Question 13 of 25 · Speed Management
Air brake lag distance at 55 mph on dry pavement adds about:
-
A.
12 feet to stopping distance
-
B.
32 feet to stopping distance
-
C.
50 feet to stopping distance
-
D.
100 feet to stopping distance
Correct answer: B.
Air brake systems have a lag of about 0.4 seconds, adding roughly 32 feet at 55 mph.
Question 14 of 25 · Foundation Brakes
Brake drums (or discs) must not have cracks longer than:
-
A.
1/4 the width of the friction area
-
B.
1/2 the width of the friction area
-
C.
3/4 the width of the friction area
-
D.
Anything is acceptable
Correct answer: B.
Cracks longer than one-half the width of the friction area are a safety violation.
Question 15 of 25 · Inspection
How much air pressure (psi) loss is allowed per minute for combination vehicles with the engine off and brakes released?
-
A.
Up to 1 psi
-
B.
Up to 2 psi
-
C.
Up to 3 psi
-
D.
Up to 4 psi
Correct answer: B.
Combination vehicles allow up to 3 psi loss per minute with brakes released; with brakes applied, up to 4 psi.
Question 16 of 25 · Parking
When parking a tractor-trailer with spring brakes:
-
A.
Use the trailer hand valve only
-
B.
Use the parking brake only — do not push the brake pedal down to hold the vehicle
-
C.
Press the foot brake and then engage the parking brake
-
D.
Set both brakes simultaneously
Correct answer: B.
Don't push the pedal down because it will cause damage. Set the parking brakes only.
Question 17 of 25 · Tanks
Why must air tanks be drained?
-
A.
To remove fuel from the system
-
B.
To remove water and compressor oil that can damage the brakes
-
C.
To inspect the tanks
-
D.
To increase pressure
Correct answer: B.
Water and oil collect in tanks. They damage seals and can freeze in cold weather.
Question 18 of 25 · Combination Air
When a tractor protection valve closes, it:
-
A.
Opens the air supply to the trailer
-
B.
Stops air from going to the trailer brakes
-
C.
Causes the parking brake to release
-
D.
Has no effect on the trailer
Correct answer: B.
When closed, it stops airflow to the trailer and applies trailer emergency brakes.
Question 19 of 25 · Speed Management
Why is it important not to over-apply the brakes?
-
A.
Brakes can overheat and fade
-
B.
Brakes will lock and skid
-
C.
You may lose control of the vehicle
-
D.
All of the above
Correct answer: D.
Over-application leads to fade, lockup, skidding, and loss of control.
Question 20 of 25 · Compressor
If the air compressor governor is not working properly:
-
A.
Air compressor may not maintain enough pressure to safely operate the brakes
-
B.
The brakes will work harder
-
C.
Brakes may not release at all
-
D.
There is no impact on safety
Correct answer: A.
A faulty governor can cause low system pressure or over-pressurization, both unsafe.
Question 21 of 25 · System Basics
Air brakes use compressed air to:
-
A.
Lubricate the wheels
-
B.
Make the brakes work
-
C.
Cool the engine
-
D.
Increase fuel pressure
Correct answer: B.
Compressed air is the working fluid that applies the brakes in an air brake system.
Question 22 of 25 · Combination Air
What component prevents air pressure loss in case of a leak between the tractor and trailer?
-
A.
Tractor protection valve
-
B.
Air dryer
-
C.
Foot brake valve
-
D.
Modulating valve
Correct answer: A.
The tractor protection valve closes off the trailer air supply during a leak, protecting tractor air.
Question 23 of 25 · Speed Management
Which of these statements is true about brake fading?
-
A.
Resting brakes does not bring back braking power
-
B.
Brake fade is caused by drums getting too hot
-
C.
Brake fade only affects new vehicles
-
D.
Brake fade only happens with disc brakes
Correct answer: B.
Brake fade results from overheated drums or discs reducing friction and braking ability.
Question 24 of 25 · Gauges
You should know your vehicle is properly equipped with which gauge?
-
A.
Two air pressure gauges (or one with two needles) showing pressure in primary and secondary tanks
-
B.
A vacuum gauge
-
C.
A voltage meter only
-
D.
A coolant gauge only
Correct answer: A.
Dual air systems require gauges for both primary and secondary air supplies.
Question 25 of 25 · ABS
If the ABS warning light comes on, you should:
-
A.
Stop driving immediately
-
B.
Continue, knowing brakes still work — but ABS may not
-
C.
Pump the brakes constantly
-
D.
Engage the trailer hand valve
Correct answer: B.
You still have normal braking; only the ABS function may be off. Get it fixed soon.
About the Air Brakes Test
The Air Brakes test covers air brake system parts (compressor, governor, reservoirs, drain valves, alcohol evaporator, safety valve, brake pedal, foundation brakes), dual air brake systems, inspecting air brakes, using air brakes (normal stops, emergency stops, parking brakes), and proper procedures for braking on downgrades. If you fail or skip the Air Brakes test, your CDL is restricted to vehicles without full air brake systems.
The Missouri Department of Revenue — Driver License Bureau administers this knowledge test as part of its commercial driver license program. To earn the Air Brakes Endorsement on your Missouri CDL, you need to score at least 20 out of 25 on the official version.
Topics covered on this practice test
- Speed Management: 4 questions
- Spring Brakes: 3 questions
- Compressor: 3 questions
- Combination Air: 3 questions
- Tanks: 2 questions
- Inspection: 2 questions
- ABS: 2 questions
- Warning Devices: 1 question
- Operation: 1 question
- Foundation Brakes: 1 question
- Parking: 1 question
- System Basics: 1 question
- Gauges: 1 question
How to use this practice test
- Read each question carefully. CDL questions are written precisely — small wording differences matter.
- Click "Show Answers & Explanations" only after answering every question. Don't peek mid-test.
- Read the explanation for every question, even ones you got right. The reasoning is more important than the answer.
- Repeat the test until you score 100%. The questions are deterministic per state, so you can track your improvement over multiple sessions.
- Move on to the other endorsement tests for Missouri until you're ready for the official exam.
Tips specific to the Air Brakes test
Air Brakes questions test your ability to identify components, follow inspection sequences, and respond to system failures. Memorize the cut-in and cut-out pressures, the low-pressure warning thresholds, the pressure ranges at which spring brakes apply, and the maximum allowable air-loss rates. Many questions have nearly-identical wording, so precision matters.