25 realistic Air Brakes practice questions for South Dakota CDL applicants. Required for: Vehicles equipped with air brake systems. Official test: 25 questions, 20 correct to pass.
Question 1 of 25 · Speed Management
Which of these statements is true about brake fading?
-
A.
Resting brakes does not bring back braking power
-
B.
Brake fade is caused by drums getting too hot
-
C.
Brake fade only affects new vehicles
-
D.
Brake fade only happens with disc brakes
Correct answer: B.
Brake fade results from overheated drums or discs reducing friction and braking ability.
Question 2 of 25 · Inspection
How much air pressure (psi) loss is allowed per minute for combination vehicles with the engine off and brakes released?
-
A.
Up to 1 psi
-
B.
Up to 2 psi
-
C.
Up to 3 psi
-
D.
Up to 4 psi
Correct answer: B.
Combination vehicles allow up to 3 psi loss per minute with brakes released; with brakes applied, up to 4 psi.
Question 3 of 25 · Tanks
What is the safety valve set to open at?
-
A.
100 psi
-
B.
125 psi
-
C.
150 psi
-
D.
180 psi
Correct answer: C.
The safety valve is normally set to open at 150 psi to protect the system from over-pressurization.
Question 4 of 25 · Spring Brakes
What happens if the air pressure drops to between 20 and 45 psi?
-
A.
Nothing happens
-
B.
The compressor cuts in
-
C.
Spring brakes apply automatically
-
D.
The trailer is released
Correct answer: C.
Spring brakes typically apply automatically in this range, stopping the vehicle.
Question 5 of 25 · Inspection
Which of the following must be checked before operating an air-braked vehicle?
-
A.
Low air pressure warning signal
-
B.
Spring brakes set automatically
-
C.
Air leakage rate
-
D.
All of the above
Correct answer: D.
All of these are required pre-trip air brake checks.
Question 6 of 25 · Spring Brakes
Spring brakes will come on automatically when air pressure drops to:
-
A.
100 psi
-
B.
60 psi or less
-
C.
20 to 45 psi
-
D.
10 psi
Correct answer: C.
Spring brakes typically apply automatically between 20 and 45 psi.
Question 7 of 25 · Spring Brakes
Where are spring brakes typically NOT found?
-
A.
Front steering axle
-
B.
Drive axles
-
C.
Trailer axles
-
D.
Tractor rear axles
Correct answer: A.
Spring brakes are found on drive axles and trailer axles, not normally on the steering axle.
Question 8 of 25 · Foundation Brakes
What's the most common type of foundation brake found on heavy vehicles?
-
A.
Disc brakes
-
B.
Wedge drum brakes
-
C.
S-cam drum brakes
-
D.
Air-over-hydraulic
Correct answer: C.
S-cam drum brakes are the most common foundation brakes on heavy commercial vehicles.
Question 9 of 25 · Parking
You should never use the trailer hand valve to park because:
-
A.
It is not strong enough
-
B.
The air could leak out, releasing the brakes
-
C.
It only applies the front brakes
-
D.
It is not connected to the trailer
Correct answer: B.
If air leaks out, the brakes release. Always use the parking brake to park.
Question 10 of 25 · Operation
When making a normal stop, what should you do?
-
A.
Push the brake pedal down so you can stop at a safe place and remain in control
-
B.
Pump the brakes
-
C.
Use only the parking brake
-
D.
Use only the trailer hand valve
Correct answer: A.
Apply pressure progressively to come to a smooth, safe stop while maintaining control.
Question 11 of 25 · Speed Management
Air brake lag is:
-
A.
The time required for the brakes to apply after the pedal is pressed
-
B.
The amount of free play in the brake pedal
-
C.
The distance traveled before the brakes release
-
D.
The time to drain air tanks
Correct answer: A.
Lag is the time between pressing the pedal and the brakes actually applying — about 0.4 seconds.
Question 12 of 25 · Bobtail
What is bobtail braking?
-
A.
Braking with no trailer attached, when the tractor brakes harder than usual
-
B.
A type of trailer-only braking
-
C.
Emergency braking on doubles
-
D.
A way to test the parking brake
Correct answer: A.
A bobtail tractor (without a trailer) brakes hard because it has less weight on the drive axles.
Question 13 of 25 · Parking
When parking a tractor-trailer with spring brakes:
-
A.
Use the trailer hand valve only
-
B.
Use the parking brake only — do not push the brake pedal down to hold the vehicle
-
C.
Press the foot brake and then engage the parking brake
-
D.
Set both brakes simultaneously
Correct answer: B.
Don't push the pedal down because it will cause damage. Set the parking brakes only.
Question 14 of 25 · Spring Brakes
What does a "spring brake" mean?
-
A.
A brake that operates only in spring weather
-
B.
A mechanical brake that uses powerful springs to apply the brake when air pressure is lost
-
C.
A specific kind of disc brake
-
D.
A backup hydraulic brake
Correct answer: B.
Spring brakes use powerful coil springs to apply the brakes when air pressure is lost.
Question 15 of 25 · Parking
On a tractor with no trailer attached, the tractor parking brake control:
-
A.
Will lock and unlock the front brakes
-
B.
Will set or release the spring brakes on the tractor
-
C.
Has no function
-
D.
Operates only the trailer brakes
Correct answer: B.
The yellow diamond control sets and releases the tractor parking (spring) brakes.
Question 16 of 25 · Warning Devices
The low air pressure warning device must come on when air pressure in the service tanks falls below:
-
A.
80 psi
-
B.
60 psi
-
C.
50 psi or 1/2 the compressor governor cut-out pressure
-
D.
20 psi
Correct answer: C.
Low pressure warnings activate at 60 psi or less (or half the cut-out pressure on older vehicles).
Question 17 of 25 · ABS
If the ABS warning light comes on, you should:
-
A.
Stop driving immediately
-
B.
Continue, knowing brakes still work — but ABS may not
-
C.
Pump the brakes constantly
-
D.
Engage the trailer hand valve
Correct answer: B.
You still have normal braking; only the ABS function may be off. Get it fixed soon.
Question 18 of 25 · Compressor
What is the purpose of an alcohol evaporator?
-
A.
Reduce alcohol in the driver's system
-
B.
Reduce risk of frozen brake valves and lines in cold weather
-
C.
Improve fuel economy
-
D.
Lubricate the air compressor
Correct answer: B.
Alcohol injected into the air system reduces freeze-up risk in cold conditions.
Question 19 of 25 · Combination Air
When should the trailer brake hand valve be used?
-
A.
To park the trailer
-
B.
To test the trailer brakes only
-
C.
To stop the entire combination
-
D.
Never to keep the vehicle from rolling
Correct answer: B.
Use it only to test trailer brakes. Never use it to park or as a service brake during normal stops.
Question 20 of 25 · System Basics
Air brakes use compressed air to:
-
A.
Lubricate the wheels
-
B.
Make the brakes work
-
C.
Cool the engine
-
D.
Increase fuel pressure
Correct answer: B.
Compressed air is the working fluid that applies the brakes in an air brake system.
Question 21 of 25 · Inspection
How do you test the low pressure warning signal?
-
A.
With the engine off, pump the brake pedal until the signal activates (must come on at 60 psi or above)
-
B.
Drive the vehicle to lose pressure
-
C.
Open the air tank drain valve briefly
-
D.
Push the parking brake control
Correct answer: A.
Pump the brake to lower pressure; warning must come on at 60 psi or higher.
Question 22 of 25 · Speed Management
Total stopping distance for an air-braked vehicle is made up of:
-
A.
Perception distance + reaction distance + brake lag distance + braking distance
-
B.
Just the braking distance
-
C.
Reaction distance only
-
D.
Brake lag distance only
Correct answer: A.
It is the sum of perception distance, reaction distance, brake lag distance, and braking distance.
Question 23 of 25 · Foundation Brakes
Brake drums (or discs) must not have cracks longer than:
-
A.
1/4 the width of the friction area
-
B.
1/2 the width of the friction area
-
C.
3/4 the width of the friction area
-
D.
Anything is acceptable
Correct answer: B.
Cracks longer than one-half the width of the friction area are a safety violation.
Question 24 of 25 · Speed Management
Air brake lag distance at 55 mph on dry pavement adds about:
-
A.
12 feet to stopping distance
-
B.
32 feet to stopping distance
-
C.
50 feet to stopping distance
-
D.
100 feet to stopping distance
Correct answer: B.
Air brake systems have a lag of about 0.4 seconds, adding roughly 32 feet at 55 mph.
Question 25 of 25 · Inspection
How can you check the slack adjusters?
-
A.
Pull hard on each slack adjuster — they should not move more than about 1 inch
-
B.
Listen for air leaks at each chamber
-
C.
Watch the brake light flash
-
D.
Look at the brake pedal travel
Correct answer: A.
Pulling hard, slack adjusters should not move more than about 1 inch where the push rod attaches.
About the Air Brakes Test
The Air Brakes test covers air brake system parts (compressor, governor, reservoirs, drain valves, alcohol evaporator, safety valve, brake pedal, foundation brakes), dual air brake systems, inspecting air brakes, using air brakes (normal stops, emergency stops, parking brakes), and proper procedures for braking on downgrades. If you fail or skip the Air Brakes test, your CDL is restricted to vehicles without full air brake systems.
The South Dakota Driver Licensing Program administers this knowledge test as part of its commercial driver license program. To earn the Air Brakes Endorsement on your South Dakota CDL, you need to score at least 20 out of 25 on the official version.
Topics covered on this practice test
- Speed Management: 4 questions
- Inspection: 4 questions
- Spring Brakes: 4 questions
- Parking: 3 questions
- Foundation Brakes: 2 questions
- Tanks: 1 question
- Operation: 1 question
- Bobtail: 1 question
- Warning Devices: 1 question
- ABS: 1 question
- Compressor: 1 question
- Combination Air: 1 question
- System Basics: 1 question
How to use this practice test
- Read each question carefully. CDL questions are written precisely — small wording differences matter.
- Click "Show Answers & Explanations" only after answering every question. Don't peek mid-test.
- Read the explanation for every question, even ones you got right. The reasoning is more important than the answer.
- Repeat the test until you score 100%. The questions are deterministic per state, so you can track your improvement over multiple sessions.
- Move on to the other endorsement tests for South Dakota until you're ready for the official exam.
Tips specific to the Air Brakes test
Air Brakes questions test your ability to identify components, follow inspection sequences, and respond to system failures. Memorize the cut-in and cut-out pressures, the low-pressure warning thresholds, the pressure ranges at which spring brakes apply, and the maximum allowable air-loss rates. Many questions have nearly-identical wording, so precision matters.