25 realistic Tank Vehicles practice questions for South Dakota CDL applicants. Required for: Vehicles with liquid or gaseous tanks ≥1,000 gallons. Official test: 20 questions, 16 correct to pass.
Question 1 of 25 · Loading
Why must tanker drivers be careful when refueling?
-
A.
Risk of fire from spills
-
B.
Risk of cargo contamination
-
C.
Risk of overloading
-
D.
Both A and B
Correct answer: D.
Spills can ignite and cargo can be contaminated by fuel.
Question 2 of 25 · Rail Crossings
What's the recommended safe practice when crossing railroad tracks with a tanker?
-
A.
Stop within 15-50 feet of nearest rail and look and listen for trains
-
B.
Speed up across the tracks
-
C.
Stop on the tracks
-
D.
Drive across normally
Correct answer: A.
Stop 15 to 50 feet from nearest rail. Don't shift gears while crossing.
Question 3 of 25 · Adverse Conditions
What's the best practice for starting on slippery roads with a tanker?
-
A.
Accelerate slowly to avoid wheel spin
-
B.
Accelerate quickly
-
C.
Use the lowest gear and slip clutch
-
D.
Use parking brake
Correct answer: A.
Smooth, slow acceleration avoids spinning the drive tires.
Question 4 of 25 · Loading
Why is it important not to overload tank vehicles?
-
A.
Overloading exceeds weight limits
-
B.
It increases risk of tank rupture
-
C.
It changes vehicle handling
-
D.
All of the above
Correct answer: D.
Overloading is illegal and unsafe; it changes handling and stresses the tank.
Question 5 of 25 · Loading
What is a vapor recovery system?
-
A.
A way to recover heat
-
B.
A system to recover vapors during loading and unloading to reduce emissions
-
C.
An air brake component
-
D.
A backup pump
Correct answer: B.
Vapor recovery captures vapors during transfer to limit emissions.
Question 6 of 25 · Speed Management
When should tank drivers especially reduce speed?
-
A.
On wet or slippery roads
-
B.
On curves
-
C.
On ramps
-
D.
All of the above
Correct answer: D.
Slow down on wet roads, curves, and ramps — all increase rollover risk.
Question 7 of 25 · Inspection
How can drivers detect a tank leak?
-
A.
Visual inspection during pre-trip and en-route stops
-
B.
Smell of the cargo
-
C.
Sound of escaping fluid
-
D.
All of the above
Correct answer: D.
Sight, smell, and sound can all help detect leaks. Inspect at every stop.
Question 8 of 25 · Speed Management
What should you do when going around curves with a tanker?
-
A.
Slow down well below the posted speed
-
B.
Drive at the posted speed limit
-
C.
Use the engine retarder
-
D.
Lock the brakes
Correct answer: A.
Take curves at speeds well below the posted limit to avoid rollovers.
Question 9 of 25 · Tank Types
What is "compartmented tanks"?
-
A.
Tanks split into multiple sections
-
B.
Tanks made for grain
-
C.
Tanks made for hazardous materials only
-
D.
Tanks with one large interior
Correct answer: A.
Compartmented tanks have multiple sections so different liquids can be carried separately.
Question 10 of 25 · Adverse Conditions
What's the safe way to handle a tanker in heavy wind?
-
A.
Slow down and grip steering firmly
-
B.
Speed up to maintain control
-
C.
Use the engine retarder
-
D.
Lock the brakes
Correct answer: A.
High winds destabilize tankers; slow down and steer firmly.
Question 11 of 25 · Vehicle Dynamics
When is liquid surge greatest?
-
A.
When tanks are full
-
B.
When tanks are partially full
-
C.
When tanks are empty
-
D.
When tanks are heated
Correct answer: B.
Surge is greatest when tanks are partially full and the liquid can move freely.
Question 12 of 25 · Vehicle Dynamics
Why is the high center of gravity dangerous?
-
A.
It increases rollover risk
-
B.
It makes the vehicle more aerodynamic
-
C.
It improves traction
-
D.
It reduces braking force
Correct answer: A.
A high CG raises rollover risk, especially in turns or sudden maneuvers.
Question 13 of 25 · Tank Types
What's a key difference between compartmented and smooth-bore tanks?
-
A.
Compartmented tanks reduce surge between sections
-
B.
Smooth-bore tanks have less surge
-
C.
They are the same in terms of surge
-
D.
Compartmented tanks are always larger
Correct answer: A.
Compartmented tanks reduce overall surge by limiting movement to each section.
Question 14 of 25 · Vehicle Dynamics
Why must drivers be especially careful when starting and stopping a tanker?
-
A.
Surge can cause loss of control
-
B.
Engine torque is too high
-
C.
Brakes are weaker
-
D.
Steering is harder
Correct answer: A.
Surge during starts and stops can shove the vehicle and cause loss of control.
Question 15 of 25 · Vehicle Dynamics
Why is liquid surge dangerous?
-
A.
It can cause the truck to roll over
-
B.
It can push the truck in the direction the wave moves
-
C.
It can affect handling and braking
-
D.
All of the above
Correct answer: D.
Surge can roll, push, and disrupt braking — drivers must anticipate it.
Question 16 of 25 · Vehicle Dynamics
How do drivers minimize side-to-side surge?
-
A.
Avoid abrupt lane changes and turns
-
B.
Take turns wide and slow
-
C.
Use partial loads
-
D.
Both A and B
Correct answer: D.
Smooth, slow inputs and wide turns help reduce side-to-side surge.
Question 17 of 25 · Mountain Driving
How do drivers control speed on downgrades with tankers?
-
A.
Use lower gears and engine braking
-
B.
Use service brakes only
-
C.
Coast with no brakes
-
D.
Use parking brake
Correct answer: A.
Use proper low gears and engine braking; service brakes only intermittently.
Question 18 of 25 · Tank Types
What is the purpose of internal baffles?
-
A.
To reduce side-to-side surge
-
B.
To reduce forward and back surge
-
C.
To prevent leaks
-
D.
To increase tank size
Correct answer: B.
Baffles reduce front-to-back surge but do not stop side-to-side surge.
Question 19 of 25 · CDL Rules
How are tanker drivers trained for hazardous cargo?
-
A.
Same as regular drivers
-
B.
They receive specialized training and may need HazMat endorsement
-
C.
No specific training required
-
D.
They are trained by the shipper
Correct answer: B.
Hazardous tankers require additional training and often a HazMat endorsement.
Question 20 of 25 · Vehicle Dynamics
How can drivers prevent tanker rollover?
-
A.
Reduce speed in curves and ramps
-
B.
Avoid sudden steering
-
C.
Maintain proper load and securement
-
D.
All of the above
Correct answer: D.
Slow speed, smooth steering, and proper loading all help prevent rollovers.
Question 21 of 25 · Inspection
What's the importance of the tank shell's integrity?
-
A.
It contains the cargo and prevents leaks
-
B.
It supports the chassis
-
C.
It absorbs shock
-
D.
It connects to the brakes
Correct answer: A.
A sound tank shell prevents leaks and contains pressure from the cargo.
Question 22 of 25 · Loading
What is "outage" in tank operations?
-
A.
Lost electricity
-
B.
Empty space allowed in a tank for liquid to expand
-
C.
Tank failure
-
D.
Loss of brake pressure
Correct answer: B.
Liquids expand with heat. Outage is the empty space left for that expansion.
Question 23 of 25 · Vehicle Dynamics
Why are tank vehicles often top-heavy?
-
A.
The cargo is dense
-
B.
The cargo's liquid weight rises with the tank shape
-
C.
They have raised cargo platforms
-
D.
The center of gravity is high due to liquid load
Correct answer: D.
Tank vehicles tend to have a high center of gravity, making them prone to rollover.
Question 24 of 25 · Vehicle Dynamics
What's a key safety feature in modern tankers?
-
A.
Automatic emergency braking
-
B.
Stability control systems
-
C.
Reinforced tank shells
-
D.
All of the above
Correct answer: D.
Modern tankers often combine ABS, stability control, and reinforced shells for safety.
Question 25 of 25 · Vehicle Dynamics
How does liquid weight affect handling?
-
A.
It changes the center of gravity
-
B.
It affects acceleration
-
C.
It affects braking
-
D.
All of the above
Correct answer: D.
Liquid loads alter CG and dramatically affect acceleration and braking.
About the Tank Vehicles Test
The Tank Vehicles test covers inspecting tank vehicles, driving tank vehicles, surge and liquid movement, baffled and unbaffled tanks, outage, and safe driving rules unique to large liquid loads. Tank vehicles handle very differently from dry-freight vehicles because liquid surge can shove the vehicle in the direction the wave moves.
The South Dakota Driver Licensing Program administers this knowledge test as part of its commercial driver license program. To earn the Tank Endorsement (N) on your South Dakota CDL, you need to score at least 16 out of 20 on the official version.
Topics covered on this practice test
- Vehicle Dynamics: 9 questions
- Loading: 4 questions
- Tank Types: 3 questions
- Adverse Conditions: 2 questions
- Speed Management: 2 questions
- Inspection: 2 questions
- Rail Crossings: 1 question
- Mountain Driving: 1 question
- CDL Rules: 1 question
How to use this practice test
- Read each question carefully. CDL questions are written precisely — small wording differences matter.
- Click "Show Answers & Explanations" only after answering every question. Don't peek mid-test.
- Read the explanation for every question, even ones you got right. The reasoning is more important than the answer.
- Repeat the test until you score 100%. The questions are deterministic per state, so you can track your improvement over multiple sessions.
- Move on to the other endorsement tests for South Dakota until you're ready for the official exam.
Tips specific to the Tank Vehicles test
Tank vehicle questions focus on liquid surge, outage, smooth-bore versus baffled tanks, high center of gravity, and the special braking and turning techniques required to keep a partially-loaded tank under control. Expect several questions about leak response and load distribution.